Soda Machine to MDB and Pulse Validator
Please see below for our selection of different kits for soda machines
-
The setup includes all parts to install a validator in a working single price soda vendor. The following parts are included:
- Refurbished MEI Series 2000 validator that accepts $1
- Refurbished single price coin changer with dollar interface
- Required harnessing
- Validator mounting bezel – only needed if factory knock out is not available
- Drilling/cutting foundation in no factory knock-out -
This setup includes the parts to install a bill acceptor in a soda vending machine with a Coinco 3340s and 9370S changer.
- Mars series 2000 validator
- Mars 120v power harness
- Harness validator power with T adapter -
This setup includes the parts to install a bill acceptor that takes $1 and $5s in a soda vending machine with a Coinco 3340s and 9370S changer.
- Mars series 2000 validator
- Mars 120v power harness
- Harness validator power with T adapter -
This kit is designed for a Dixie MPC vendor with the connector for the single price changer is utilized. This is not the ideal interface as all sodas need to be sold for the same cost. The reason this kit would be utilized is if the section of the control board that controls the dumb mech is defective. The preferred kit interfaces through the dumb mech connector.
-
This MDB module kit fits Royal Vendors Merlin 2000 series vendors. It works with boards with the micros labels as follows; 1.xx, 2.xx, and 5.xx. The on location installation time is approximately 15 minutes.
-
